is
a balanced mixture of morpholine, diethyl-amino-ethanol and cyclo-hexylamine,
designed to operate in all kind of steam circuits,
Short
, like Power plants,
Medium
, like conventional medium and food industry,
Extended
, like Petrochemical plants, Paper mill, Steel and
metallurgical plants
Advantages
Theblend of the three
neutralizing amines, combine the high basicity to the characteristics
of low, medium and high distribution ratios. So WSB®DEA-3000 travels
anywhere in the system, condensates in any steam portion and :
Inhibits steam-condensate corrosion caused by carbon dioxide and/or long
and/or branched steam systems as well as very short runs including
boiler-room machinery. Inhibits corrosion in vapor-phase processes such as
certain refinery processes and in some waste oil recovery operations.
Provides corrosion protection where chloride, sulfide, sulfate, carbon
dioxide, and organic acids are present.
Provides corrosion protection to cold-end
equipment in the flue gas systems
of gas-fired boilers and furnaces. Carbonic acid and sulfuric acid corrosion
can be severe in such equipment, especially in very high efficiency
installations which operate at / or near, condensation conditions.
Provides corrosion protection to cold-end
equipment in the flue gas systems
of gas-fired boilers and furnaces. Carbonic acid and sulfuric acid corrosion
can be severe in such equipment, especially in very high efficiency
installations which operate at / or near, condensation conditions.
Application
The product dosage rate will depend on system design, water characteristics
and operational parameters.
When used to protect a steam system, WSB®DEA-3000 may be
added directly to the boiler with other boiler treatment chemicals.
The
suggested dosing rate of
WSB®DEA-3000, when used as a steam / condensate
corrosion inhibitor, is to
obtain pH 8,5-9,3 in the condensate.
When used to protect equipment in a vapor-phase process, or in a flue gas
system WSB®DEA-3000 should be injected continuously into
the gas stream and/or the wash water (if used).
The
required dosage of WSB®DEA-3000, can be estimated at
25-50 ppm in the vapor. This initial estimate may have to be adjusted upward
or downward by to a considerable extent depending on the nature of the
process.
The required dosage of WSB®DEA-3000, when used as a
flue-gas corrosion inhibitor, can be estimated at 1 gallon per 750,000 cu.
ft. of natural gas burned.
Safety
Wear suitable protective gloves and safety goggles. In case of contact
immediately flush with plenty of water. After eye contact seek medical advice. In case of
spillage absorb with sand or other absorbent materials and sweep up.
Observe the warning label on product container. Before use please refer to
material safety data sheet (MSDS) for additional information on wealth and
safety handling features.
Purpose
Advantages
Application
Safety
Water Services © 2008 - All rights
reserved