WSC 8800 corrosion inhibitor is used for the control of corrosion and fouling in open recirculating cooling water systems. 

It is best utilized in systems where the corrosion or fouling potentials are severe, or the presence of traditional heavy metal corrosion inhibitors in the plant effluent would make it unacceptable for discharge.

WSC 8800 is a carefully formulated blend of inorganic and organic, phosphorous corrosion and scale inhibitors.

WSC 8800 also contains a newly developed synthetic polymer and specific sequestering agents. Calcium carbonate scale formation, calcium phosphate sludging and iron fouling are minimized through its use.

These antifoulants greatly extend the pH range in which the product's optimum functionality is found.

WSC 8800 affords anodic and cathodic corrosion control, thus insuring the protection of a wide variety of metals. WSC 8800 does not contain chromate, zinc, borate or any other heavy metal.

The product dosage will depend on the type of system and operational parameters.

Recommended feeding method is continuously as received or as an aqueous solution to a cooling waterline, cooling tower basin or spray pond. The feeding equipment should be of plastic or stainless steel construction.

Wear suitable protective gloves and safety goggles. In case of contact immediately flush with plenty of water. After eye contact seek medical advice. In case of spillage, absorb with sand or other absorbent materials and sweep up. Then flush the area with water. Before use review the Material Safety Data Sheet for additional information.

A.D.R. : not classified

IMDG : not classified

U.N.nr. : not classified

Symbol : not regulated

R-phrases : none

S-phrases : none

WSC 8800 is packed in 30 and 250 kg PE drums.